J-bond Computer Systems Corp.


Here is a list of these support files :

File Name       Description                  size (bytes)
*********************************************************

flash.exe       BIOS update utility          3614


XXXXXXXX.bin    new BIOS filename            131072
                

************   Updating Your System BIOS   ************

To update your system BIOS, perform the steps described below. Please read
through all of the steps carefully before beginning.

1. Make sure there is a MXIC 28F1000 (Vpp=12v) flashable BIOS EPROM on your
   system board.

2. Please jump JP12=1-2,5-6 before power-on.

3. Boot your system from a DOS system diskette that contains no config.sys
   or autoexec.bat file. (If the diskette contains a config.sys or
   autoexec.bat file, the BIOS updating program will not work properly.)

4. Place the BIOS update disk into drive A (or drive B). The BIOS update
   disk contains TWO files: there are AWDFLASH.EXE and the new BIOS data
   file XXXXXXXX.BIN. Run the following command line:

   AWDFLASH XXXXXXXX.BIN

   When the program asks "Do You Want To Save Bios (Y/N)", answer N.
   When the program asks "Are you sure to program (y/n)", answer Y.

   After finishing flashing, reboot your system. Then the procedure of
   updating BIOS is done.

5. After updating BIOS is completed, please turn off the power and jump 
   JP12=2-3,4-5 again, then all action for Update BIOS is done.

!! IMPORTANT: Do not power off or reset the computer while the BIOS updating
              operation is in progress. If you do so, you will never be
              unable to start your system again.
