            

  -Follow these instruction to install the information file into Windows 95


  -This file is intented for use with the E-IDE controller card.

  -This file allows the Port Address and IRQ of the controller card
   to be manually set if the standard IDE Controller does not work
   with E-IDE card.

 -Refer to your system information. 
 ( You can know your system information, used IRQ,I/O address in properties
  under device mannager.
  Easy test method : run the program fv2.exe in dos mode 
                     under not install CD-ROM ) 

  -6/19/96  L.G. Electronics Inc.

Click on START
Select Settings
Select Control Panel
Select "Add New Hardware"
Select "Next"
Select "NO" to select the driver manually
Select "Next"
Select "Hard Disk Controllers"
Select "Next"
Select "Have Disk"
If you received a diskette with the driver on it, put the disk in the drive
and select that drive letter
(If you Downloaded the driver,Browse and select the directory  
that you expanded the self extracting file WIN95INF.EXE )
and hit "OK" 
You should select one of "GoldStar E-IDE CD-ROM IRQ=XX Controller" List.
      ( Your choice should correctly match the setting of E-IDE Card or port 
        and not conflict other device.
        List of controller:
        IRQ=10,I/O ADDRESS=168-16F,36E-36F
        IRQ=11,I/O ADDRESS=1E8-1EF,3EE-3EF
        IRQ=15,I/O ADDRESS=170-177,376-376(SECONDARY)
        IRQ=14,I/O ADDRESS=1F0-1F7,3F6-3F6(PRIMARY)) 
Select "Next" 
Select "Next"
Select "Finish"
Windows will ask you if you want to shut down, 
Remove the floppy Disk and select YES
After the computer reboots, the drive should be present.

  **  If the drive is not present, open "Device Manager"
      under Control Panel - System Select Hard Drive Controllers,
      GoldStar CD-ROM Controller, Resources and verify that the port address
      and IRQ are set according to the settings on the Interface Card.
      ( IRQ=10,I/O ADDRESS=168-16F,36E-36F
        IRQ=11,I/O ADDRESS=1E8-1EF,3EE-3EF
        IRQ=15,I/O ADDRESS=170-177,376-376(SECONDARY)
        IRQ=14,I/O ADDRESS=1F0-1F7,3F6-3F6(PRIMARY)) 
 
  *** If the DOS device drivers(mscdex.exe) are loading in autoexec.bat,
      remark the statements out to eliminate any conflicts in Windows 95.
      You should not remove "gscdrom.sys" in config.sys for using ms-dos mode.
   
  